Videos

Note

  • These videos are not intended to replace the help content of MBS but to compliment the existing help sections on MBS. MBS users are strongly encouraged to view both the help and the PEs along with these videos for better understanding.
  • It is our constant endeavor to assist the MBS users across the globe to use this tool in most efficient and productive way. And this is one step in that direction.
MBS Software Demo and Overview
Activating Metric Units
How to Remove Concrete Notch in Anchor Bolt Plans
Adding Camber to Endwall frames when there is a Wide Opening
Labeling and standardizing welded clips
Floor system input demo
Floor system data setup
Z Purlin Orientation – top flange towards or away
Wide Endwall Openings Options O and B
Creating Templates for Galvanized Finish
Endwall to Endwall Building Input Review
How to Add Special Girts
Supported Canopy feature for open Lean-to attached to main building — data Entry and Setup
Insight into Latest Costing within MBS
New Clash Detection Functionality
Costing for Framing Colors using DB_USER rule and Job Info screens
Hole Oversize Settings in MBS
How To Include or Exclude Anchor Bolts from the BOM
Anchor Bolt Plan Base Plates in Full Scale
How to Change the Piece Mark Start Number to User Choice instead of Default integer 1
Hip features for Extensions
How To Use BOMCHECK Feature
How To Show Weld Symbols on Assembly Drawings
Wind Bent Detailing Options
Roll out of the new DBCHECK feature
Creating logos for Erection drawing sheets
Creating logos for Shop drawing sheets